Context provides classic reverb sounds to place your instrument in a room, hall, cathedral, metal plate, or less natural surroundings. All of the algorithms are adjustable so that you can get the right combination of pre-delay, reverb time, and frequency response. The plate algorithm gives you control over low- and high-frequency response for crisp, defined reverb even with bass instruments. Gated reverb gives you big booming drums from the 1980's, but is also great for adding power to guitar while maintaining transparency and space between notes. Finally, there is delay plus reverb for that versatile combination in a single pedal.
Context adds depth to your sound without unwanted coloration. The dry signal passes through Burr-Brown op amps and WIMA poly film caps in a 100% analog signal path. An internal switch selects between true bypass and trails. True bypass completely removes the Context from your signal path when not needed. Trails allows the reverb to decay naturally, and also works as a high-quality buffer. With trails on, the blend control is active in bypass to maintain a consistent volume.
blend adjusts wet/dry blend, up to 100% wet.
delay sets pre-delay, to simulate natural spaces or increase presence.
decay adjusts reverb time, from very tight to Packard Plant sized.
damping adjusts high-frequency response, to keep the reverb from taking over other instruments' space or create dark ambience.
Room - fast buildup.
Hall - slow buildup with moderate diffusion.
Cathedral - bright reverb with extended response.
Gated - adjustable gate time with nonlinear decay.
Plate - bright and dense reverb with adjustable reverb time, low- and high-frequency response.
Delay - adjustable delay time, repeats, and reverb amount.
• True bypass switching or trails, selectable via internal switch.
• Minimal signal path.
• Mono in/out.
• 4.7" x 3.7" enclosure, drilled, powder coated, and laser etched in-house.
• 24 bit A/D and D/A converters.
• High quality components (Burr-Brown op amps, WIMA poly film caps, Neutrik jacks).
• Requires 9V center negative 100 mA power supply (not included). Does not take batteries.
• Made in USA, from circuit boards to final assembly.